e-Shop Katalog

Accessories


Preparation for lapping

  1. Degrease and clean the steel or tin disc with 3M Industrial Cleaner or Ecorange No. 515810
  2. Start the machine at 500 rpm, apply the adhesive spray 3M 75 No. 515809 evenly
  3. Stop the machine and lift up the latex paper No. 515820 and smooth it from the middle outwards
  4. Cut the protruding latex carrier with a cutter knife at a small turn to fit it
  5. Repeat procedure (points 2. to 4.) with desired abrasive paper
  6. On new sandpaper, level out the grain with a rounded piece of brass
  7. Apply grinding grease no. 515811 to prolong the service life
Subgroups
  • glue spray
    nameVersioncontentsitem No.
    glue sprayfor lapping machines500 ml515809
  • grease remover / cleaner
    nameVersioncontentsitem No.
    grease removerfor lapping machines500 ml515810
  • sanding grease
    namefield of applicationcontentsitem No.
    sanding greasefor sandpaper500 g515811
    Stearinfor sandpaper500 g515908
  • protection lacquer
    nameVersionadditioncontentsitem No.
    protective lacquerNGL 2002 Rose100% water soluble400 ml507758
  • masking tape
    nameVersionwidthlengthadditionitem No.
    Masking tapeheat-resistant2,0mm33mroll507967
    Masking tapeheat-resistant3.0 mm33mroll507968
    masking tapeheat-resistant4.0 mm33mroll507981
    masking tapeheat-resistant6.0 mm33mroll507982
    masking tapeheat-resistant9.0 mm33mroll507983
    masking tapeheat-resistant19.0 mm33mroll507984
  • dispenser
    nameVersionitem No.
    dispenserfor masking tapes507969

fits to it

more interesting products

Use of cookies

Boley uses cookies to optimize the design of this website and make continuous improvements. By continuing your visit the website, you consent to the use of cookies. Further details can be found in privacy policy .